Section 02 – Cattle Milk Recording

Introduction

Information about milk production traits is very important for managing and breeding dairy herds. The milk recording process starts with the collection of animal identification, a calving date of milking cows, the amount of milk given and the date with time or time frame of a day. A milk sample may be taken. The obtained milk sample is analysed for milk constituents. The results of the analysis plus the data about milk yield and time of milking are stored in a database. Subsequently a number of parameters, cumulative yields and indices are calculated and stored in the database and, finally, reported to the farmer

This section (2) of the ICAR Guidelines focuses on the milk recording process for dairy cattle.

Definition and terminology

A list of important definitions for terms and abbreviations used in these guidelines is provided by Cattle Milk Recording#Definition and terminology

Table 1. Definitions of Terms used in these guidelines.

Term	Definition
24-hour yield	The amounts of milk, fat and protein produced by the individual cow over 24 hours.
Accumulated yield	The amounts of milk, fat and protein produced by the individual cow during an appointed period of time, e.g. a calendar year.
AMS	Automatic Milking System
Average yield	The amounts of milk, fat and protein produced by all cows in the herd in average during the appointed time period.
Expected milk secretion rate	Average milk secretion rate of a cow calculated as grams per minute of a given period of time.
Expected milking interval	Average milking interval of a given time period.
Individual milking	A single act of collecting milk from one cow.
Individual milking yield	The amount of milk produced by a cow in an individual milking.
Interrupted milking	A milking is considered interrupted if the milk secretion rate is less than 80% of the expected.
Lactation	The period from an individual cow’s calving to her dry off or culling (lactation can be incomplete)
Lactation yield	The amount of milk, fat and protein produced by an individual cow during the lactation.
Milk analysis results	The set of milk constituents (e.g. fat, protein, lactose, urea, somatic cell count) in a milk sample analysed by a laboratory.
Milk recording	The whole process of milk data collection described in paragraph 1 of this guideline. This is also known as Dairy Herd Improvement (DHI).
Milk secretion rate	Milk secretion rate of a cow calculated as grams per minute for the milking interval.
Milking interval	The period between two consecutive milkings.
Recorded cow	Any cow in a recorded herd.
Recorded herd	Any herd that is enrolled in milk recording.
Recording	The action of measuring a cow’s milk yield by collecting the data and processing it (e. g. by use of a database). This is also known as testing or test day.
Recording interval	The period between two consecutive recordings.
Recording period	The period between the end and beginning of the recording on a single recording.
Sample position	Position of the sample in the sampling unit.
Sampling	The action of taking a representative sample of a cow’s milk. Sampling is generally attached to a recording.
Sampling unit	A device for the collection of milk samples.
Standard lactation	The period from an individual cow’s calving until her dry off or 305th day since her calving.
Unrecorded milking	A milking is considered unrecorded if the milking interval is longer than expected and milk secretion rate is less than 80% of the expected.
Vial	The vessel containing a milk sample, also known as bottle etc.

Scope

Figure 1 gives a pictorial summary of the main elements of this guideline.

In summary, this section of the ICAR Guidelines covers the milk recording process from the enrolment of a herd for milk recording, through to the delivery of information which a herd owner can use to assist in a range of decisions.

Figure 1. Scope of Section 2 -Dairy cattle milk recording.

Not covered in this section are:

1. Standards and guidelines for ICAR approval of milk recording devices. Please consult Section 11 for this subject.
2. Standards and guidelines for ICAR approval of ID devices. Please consult Section 10 for this subject.
3. Standards and guidelines for preparation of milk samples and for quality assurance of milk analysis. Please consult Section 12 for this subject.
4. Standards and guidelines for in-line milk analysis on the farm. Please consult Section 13 for this subject.

Enrolment

Enrolment of new herds in the recording process should involve an agreement between the farmer and the recording organisation regarding technical and financial questions such as:

1. General information about the recording programme itself, i.e.
   1. Herd and cow identification.
   2. Scope of recorded data, including database setup as required by the user.
   3. Scheduling recording.
   4. Data capture and processing.
   5. Recording methods and intervals.
   6. Milk measuring and meters.
   7. Sampling and sample transport.
   8. Reports (outcomes) and supporting decisions.
2. Definition of supervision scheme and other quality assurance and plausibility checking steps.
3. Fee structure and invoicing.
4. Approval of technicians by milk recording organisations (MROs) so as to give them free access to farms for all recording and supervision actions.

In cases where the owner of the recorded cows or his employees carry out the recording itself, it is up to the organisation to decide upon, and provide for, any necessary training.

Recording

Standards and Guidelines for milk recording

These standards and guidelines for milk recording are valid for all milking systems, including AMS where applicable.

General Standards and Guidelines for milk recording

1. ICAR-approved (electronic) milk meters and sampling devices must be used on the recording day (see Procedure 1 of Section 11 - Guidelines for Testing, Approval and Checking of Milk Recording Devices). The list of approved milk meters, jars and AMS and automatic milk sampler/tray combinations sampling devices can be found on the ICAR web page.
2. Milk weights are recorded for each milking of the recording period. The measurement may be done using any of the ICAR approved recording devices, or by weighing. The minimum accuracy of the measurement is 0.2 kg.
3. Where milk constituents are analysed, the equipment used must meet ICAR standards for accuracy. Please consult Sections 12 and 13 of the Guidelines for details.
4. The accuracy of the equipment used for milk recording and sampling must be checked by an agency approved by the member organisations, on a regular and systematic basis using methods approved by ICAR. The list of methods is given in Procedure 6 of Section 11 - Procedure for Evaluation of Installation and Routine Calibration Procedures for Recording and Sampling Devices.
5. All analyses of the constituents of a milk sample must be carried out on the same milk sample.
6. These samples should ideally represent the 24-hour milking period.
7. If milk samples do not represent a 24-hour period, the results of milk analyses must be corrected to a 24-hour period by a method approved by ICAR (see 9.4 Standard methods for calculating 24 hour yields).
8. In cases where the duration of recording deviates from 24 hours, the results must be converted into 24-hour yields. Only approved 24-hour yield calculation methods can be used. The appropriate methodology is described in (9.4 Standard methods for calculating 24 hour yields).
9. As date of recording, we recommend to use the date on which the last sample was taken. As alternative, the date of the first sample can be used.
10. Calculation methods
    1. The quantities of milk and milk constituents shall be calculated according to one of the methods outlined in this section of the ICAR Guidelines (see 9.4 Standard methods for calculating 24 hour yields).
    2. Member organisations should keep the ICAR Secretariat informed about the calculation methods being used by the records processing operations in their organisation or country and shall be responsible for ensuring that the records are corrected and calculated as specified in this section of the ICAR Guidelines.

Standards and Guidelines for milk recording using AMS

This subsection covers systems where milk weights, milk quality or other traits of the cows are monitored constantly and automatically. This can be done in both automatic and manually operated milking systems.

Requirements:

1. Animal identification is automatic and reliable. Farm transponders can also be used for automatic identification if they are linked to the cow’s official identification in farm software.
2. All individual milkings must be recorded from all AMSs in the farm and transmitted to the recording database for calculation, interrupted milkings included.
3. For official milk recording purposes, the data file obtained from electronic milk meters must contain the following: 1) Cow ID, 2) Milking time stamp, 3) Milk weight and 4) Sampling stamp to mark the milking where the sample comes from.
4. All milkings within the recording period may be sampled, and in this case the samples should be analysed separately. Alternatively, a one-milking sample can be taken for each cow, followed by fat correction calculation.
5. All cows in milk on the recording day have to be sampled. The sampling device must remain in operation until all cows are sampled. When the number of available sampling devices is smaller than the number of AMS units, sampling may need to be prolonged beyond one day to allow complete sampling of all cows. In that case, the sampling device has to be moved between AMS units.
6. During sampling, the automatic sampler must be monitored to make sure there are vials left for the next cows.
7. 24-hour yield calculations must be carried out by a MRO, independently of the AMS manufacturer. This is done in order to guarantee harmonisation of calculation methods between the different brands of equipment and software.
8. Data of all milkings over a given time period must be collected for the 24-hour milk yield calculation. A 96-hour data collection period is recommended.

Recommendations:

1. Ideally, data of all milkings should be collected and used to compute lactation yield.
2. Description of formats to exchange data recorded by an AMS can be requested from the manufacturer or the ICAR ADE data exchange standard for milking data can be used.
3. In the case of milk recording method B (see 5.4.1) with AMS, the milk recording organization should make sure that the farmer knows how to load or transfer data.
4. Data can be extracted by: 1) manual operation by MRO Technician’s or Farmer (file extraction), 2) automated system and data transfer through an Application Programming Interface (API), 3) another data transfer and exchange system.
5. Raw milk recording data from the AMS must be easily accessible for MRO data processing.
6. For official milk recording purposes, the data file obtained from electronic milk meters may also contain the following: 1) Vial ID (this is obligatory with M sampling scheme), 2) Milking duration, 3) Milking speed, 4) Incomplete milking in automatic milking systems and 5) Other relevant data measured or reported by the equipment.
7. Individual milkings should be tested for milk secretion rate in order to detect interrupted and unrecorded milkings, which in turn have an effect on the calculated 24-hour yields. If there is an interrupted milking or a milking that follows an interrupted milking at the beginning of the recording period, these two milkings must be excluded from the calculations. During the recording period they can be excluded but do not need to be.
8. It is recommended to individually sample all milkings within the 24-hour recording period for 24-hour fat content calculation due to the high variability of milking frequency and milk fat content. In cases where sampling all milkings is not possible, please consult Chapter 2 of Procedure 1 of Section 2 for approved correction calculation methods.
9. It is recommended to sample only milkings with a preceding interval longer than 4 hours